Deutsch
English
Description
Industrial IEEE 802.11 b/g/n wireless access point with 2x10/100/1000 Base-T(X), 1 port PoE P.D
IGAP-420 is a reliable WLAN Access Point with 2 Ethernet Gigabit ports and IEEE 802.11 b/g/n wireless modules. It can be configured to operate in AP/Bridge/Repeater/AP-Client mode. You are able to configure IGAP-420 by WEB interface via LAN port or WLAN interface. IGAP-420 provides dual Ethernet ports in switch mode, so that you can use Daisy Chain to reduce the usage of Ethernet switch ports. In addition, IGAP-420 series also provides P.D. feature on ETH2 which is fully compliant with IEEE802.3af PoE P.D. specification. Therefore, IGAP-420 is one of the best communication solutions for wireless applications on the industrial network..
• High Speed Air Connectivity: WLAN interface support up to 300Mbps link speed
• Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported
• Support X-Roaming < 60 ms
• Support wireless load balance
• Support MAC Filter
• Support Long Distance Air Connectivity
• Provide Digital Input and Digital Output
• Support AP/Bridge/Repeater/AP-Client Mode
• Switch Mode Supported: Daisy Chain support to reduce usage of switch ports
• Dual redundant Ethernet port support redundant mode
• Wireless connecting status monitoring
• Secured Management by HTTPS
• Event Warning by Syslog, Email, SNMP Trap, Relay and Beeper
• Rigid IP-30 housing design
• DIN-Rail and Wall-mount enabled
Specification
- Physical Ports
- 100/1000Base-T(X) Ports in RJ45 Auto MDI/MDIX
- 2
- 5-Pin Terminal Block
- 4(DI and DO)
- Antenna Connector
- 2
- P.O.E. PD port
- Present at ETH2
- Fully compliant with IEEE 802.3af Power Device specifi cation
- Over load & short circuit protection
- Isolation Voltage : 1000 VDC min.
- Isolation Resistance : 108 ohms min
- WLAN interface
- Operating Mode
- AP/Bridge/Repeater/AP-Client
- Antenna and connector
- Reverse SMA Female
- Radio Frequency Type
- DSSS
- Modulation
- IEEE802.11b: CCK, DQPSK, DBPSK
- IEEE802.11g: OFDM with BPSK, QPSK, 16-QAM, 64-QAM
- IEEE802.11n: OFDM with BPSK, QPSK, 16-QAM, 64-QAM
- Frequency Band
- America/FCC: 2.412~2.462 GHz (11 channels)
- Europe CE/ETSI: 2.412~2.472 Ghz (13 channels)
- Transmission Rate
- IEEE802.11b: 1/ 2/ 5.5/ 11 Mbps
- IEEE802.11g: 6/ 9/ 12/ 18/ 24/ 36/ 48/ 54 Mbps
- IEEE802.11n:up to 300Mbps
- Transmit Power
- 802.11b: 17dBm ± 1.5dBm@11Mbps
- 802.11g: 16dBm ± 1.5dBm@54Mbps
- 802.11gn HT20: 15dBm ± 1.5dBm @MCS7
- 802.11gn HT40: 14dBm ± 1.5dBm @MCS7
- Receiver Sensitivity
- 802.11b : -85dBm ± 2dBm@11Mbps
- 802.11g : -76dBm ± 2dBm@54Mbps
- 802.11gn HT20:-75dBm ± 2dBm@MCS7
- 802.11gn HT40:-72dBm ± 2dBm@MCS7
- Encryption Security
- WEP: (64-bit ,128-bit key)
- WPA/WPA2 PSK :TKIP and AES encryption (802.11i)
- 802.1X/RADIUS Authentication supported
- Wireless Security
- SSID broadcast disable
- Protocol Support
- Protocol
- ARP, BOOTP, DHCP, DNS, HTTPs, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP (IEEE 802.1D)
- LED Indicators
- Power Indicator
- 3 x LEDs, PWR1(2)(PoE) / Ready:
- Red On : Power is on and booting up
- Green On : Power is on and functioning Normal
- 100/1000TX RJ45 Port Indicator
- 2 x LEDs,
- LNK/ACT:Green for port Act.
- Speed: Green for port Link at 1000Mbps
- Amber for port Link at 100Mbps.
- Off for port Link at 10Mbps
- WLAN LEDs
- 1 x LED, Green for WLAN Link/ Act
- Fault
- 1 x LED, Red for Ethernet link down or power down indicator
- Fault contact
- Relay
- Relay output to carry capacity of 1A at 24VDC
- Power
- Redundant Input Power
- Dual DC inputs. 12-48VDC on 6-pin terminal block
- Power Consumption (Typ.)
- 8.5W
- Overload Current Protection
- Present
- Reverse Polarity Protection
- Present
- Physical Characteristic
- Enclosure
- IP-30
- Dimension (W x D x H)
- 74.3(W) x 109.2(D) x 153.6(H) mm (2.93 x 4.3 x 6.05 inch.)
- Weight (g)
- 1150
- Environmental
- Storage Temperature
- -40 to 85°C (-40 to 185°F)
- Operating Temperature
- -25 to 70°C (-13 to 158°F)
- Operating Humidity
- 5% to 95% Non-condensing
- Regulatory approvals
- EMI
- FCC Part 15, CISPR (EN55022) class A
- EMS
- EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS),EN61000-4-8, EN61000-4-11
- Shock
- IEC60068-2-27
- Free Fall
- IEC60068-2-32
- Vibration
- IEC60068-2-6
- Safety
- EN60950-1
- Warranty
- 5 years
Filter criteria
- Customs Tariff Number
- 85176200
- Applications
- Fleetmanagement/Logistics
- Status
- Phased out
- Manufacturer
- ORING